4.Main Content
guidance
Explaining rms voltage and current
There are many ways of explaining root mean square (rms) voltage and current at different levels of complexity, to advanced level students.
1 For the simplest level, say you take the current (or potential difference) at each instant in turn, square it, add up the squares (which are all positive) and divide by the number of samples to find the average square or mean square. Then take the square root of that. This is the 'root mean square' (rms) average value.
For example: suppose the time samples are as shown in the diagram:
| Values | 0 | 7 | 10 | 7 | 0 | -7 | -10 | -7 |
| Squares | 0 | 49 | 100 | 49 | 0 | 49 | 100 | 49 |
Sum of squares = 396
Average of squares = 396/8 = almost 50
Square root ~ 7
With more intervals the rms average turns out to be (peak value) / √2 = peak value/1.41 = 0.707peak value
2 For those who are familiar with the graphs of sine and cosine functions, then the following algebraic method can be attempted.
I = Iosin ωt and I2 = Io2 sin2ωt
The heating effect depends on I2R, and so an average of I2 is needed and not an average of I.
To find the rms average value, you need the average value of sin2 as time runs on and on.
The graph of sinωt and the graph of cosωt look the same, except for a shift of origin. Because they are the same pattern, sin2ωt and cos2ωt have the same average as time goes on.
But sin2ωt + cos2ωt = 1. Therefore the average values of either of them must be 1/2.
Therefore the rms value of Iosinωt must be Io /√ 2
The rms value is 0.707 times the peak value, and the peak value is 1.41 times the value the voltmeter shows. The peak value for 230 V mains is 325 V.
3 Alternatively: Plot a graph of sin2Ө. Cut the graph in half and turn one half upside down, or copy onto a transparency and fit together. The two halves fit together exactly, showing that the mean value is 1/2.
4 Note that, when using unsmoothed rectified AC from a simple power supply, the estimate of the power obtained by multiplying the readings of a moving coil DC voltmeter and a moving coil ammeter is likely to be nearly 20% too low. This is because each moving coil meter measures the simple time-average of the half-cycle humps, not the rms average.
The rms values of current and voltage multiplied together give the actual power. This is a vital fraction when trying to do quantitative power and energy experiments such as specific thermal capacity. The values are only 80 % of the value at best.
Updated 8 Aug 2007