Switch to: text only


2.Sponsors

Sponsored by:

End of Section Back to top


3.Current Location

You are in: Home > Topics > $topics.title > Collections > Weighing a sample of air – a rough estimate

End of Section Back to top


4.Main Content

experiments

Weighing a sample of air – a rough estimate

Demonstration

Showing that the mass of air in a bottle is small.

Apparatus and materials


Technical notes

1 Instead of the special nature of the Pyrex flask, you may prefer to use a more familiar glass bottle.
 
2 For connection to the vacuum pump, it will be necessary to use pressure tubing.

Safety

Wear eye protection when evacuating glass containers or handling them. Protect observers by using a safety screen. Use a flask that can withstand the pressure difference. Check it has no specks or marks.

Read our standard health & safety guidance

Procedure

a The one litre flask must have a well-fitting rubber bung with a glass tube through it, to which is attached a rubber tube with a screw clip. Weigh the flask.
Weighing a sample of air
b Attach the rubber tubing to the pump and evacuate the flask. Reweigh the flask. (The volume can be found by filling the flask with water and pouring into the measuring cylinder.)


Teaching notes

1 It is a useful order of magnitude to remember that 1 cm3 of water has a mass of 1 gram and a litre of air has a mass of just over 1 gram (1.2 gram/litre). Students should be able to come up with their own ideas for how to make the measurements.
 
2 A one litre round-bottomed Pyrex flask weighs approximately 350 g. The change in mass when the air is removed is of the order of 1.2 g. On the single-pan lever-arm balance this amount will scarcely be appreciated. The object of this experiment is to show how small the mass difference is, in fact too small for the balance to measure.
 
3 The suggestion of weighing a balloon empty, then blowing it up full of air and weighing it again may arise. This is a fallacy quoted by Galileo. A bladder full of air gives the same reading on the balance as it does when squashed flat, because the buoyancy of the surrounding air just compensates for the weight of the air inside in the first case. A rubber balloon does weigh a little more when inflated, because the air inside is at slighter greater pressure, but that is not sufficient for use here. The volume of the container must not change much between our two weighings because it is ignored.
 
4 The lever-arm balance will probably not register a change in mass when the flask is evacuated but a top pan electronic balance will. This is a useful lesson to learn - that of choosing the best instrument for the job.
 
This experiment was safety-checked in July 2007.

Related Content

Related Experiments

Your Ideas

Schemes of work

[Simply copy and paste the experiment information below into a scheme of work.]

Weighing a sample of air – a rough estimate http://www.practicalphysics.org/go/Experiment_871.html

Showing that the mass of air in a bottle is small.

Updated 9 Jun 2010

5.Useful Tools

Useful Tools: Schemes of work | Email this page | print this page

End of Section Back to top